LTM4601AHV
DECOUPLING REQUIREMENTS
T A = 25°C, V IN = 12V. Use Figure 1 configuration.
SYMBOL
C IN
C OUT
PARAMETER
External Input Capacitor Requirement
(V IN = 4.5V to 28V, V OUT = 2.5V)
External Output Capacitor Requirement
(V IN = 4.5V to 28V, V OUT = 2.5V)
CONDITIONS
I OUT = 12A
I OUT = 12A
MIN
20
100
TYP
30
200
MAX
UNITS
μF
μF
OPERATION
Power Module Description
The LTM4601AHV is a standalone nonisolated switching
mode DC/DC power supply. It can deliver up to 12A of
DC output current with some external input and output
capacitors. This module provides precisely regulated output
voltage programmable via one external resistor from 0.6V DC
to 5.0V DC over a 4.5V to 28V wide input voltage. Typical
application schematics are shown in Figures 19 and 20.
The LTM4601AHV has an integrated constant on-time
current mode regulator, ultralow R DS(ON) FETs with fast
switching speed and integrated Schottky diodes. The typical
switching frequency is 850kHz at full load. With current
mode control and internal feedback loop compensation,
the LTM4601AHV module has sufficient stability margins
and good transient performance under a wide range of
operating conditions and with a wide range of output
capacitors, even all ceramic output capacitors.
Current mode control provides cycle-by-cycle fast current
limit. Besides, foldback current limiting is provided in an
overcurrent condition while V FB drops. Internal overvolt-
age and undervoltage comparators pull the open-drain
PGOOD output low if the output feedback voltage exits a
±10% window around the regulation point. Furthermore,
in an overvoltage condition, internal top FET Q1 is turned
off and bottom FET Q2 is turned on and held on until the
overvoltage condition clears.
Pulling the RUN pin below 1V forces the controller into its
shutdown state, turning off both Q1 and Q2. At low load
current, the module works in continuous current mode by
default to achieve minimum output ripple voltage.
When DRV CC pin is connected to INTV CC an integrated
5V linear regulator powers the internal gate drivers. If a
5V external bias supply is applied on the DRV CC pin, then
an efficiency improvement will occur due to the reduced
power loss in the internal linear regulator. This is especially
true at the high end of the input voltage range.
The LTM4601AHV has a very accurate differential remote
sense amplifier with very low offset. This provides for
very accurate output voltage measurement at the load.
The MPGM pin, MARG0 pin and MARG1 pin are used to
support voltage margining, where the percentage of margin
is programmed by the MPGM pin, and the MARG0 and
MARG1 select margining.
The PLLIN pin provides frequency synchronization of the
device to an external clock. The TRACK/SS pin is used
for power supply tracking and soft-start programming.
For more information www.linear.com/LTM4601AHV
4601ahvfc
9
相关PDF资料
LTM4601AIY#PBF IC DC/DC UMODULE 12A 133-BGA
LTM4602IV#PBF IC DC/DC UMODULE 6A 104-LGA
LTM4603HVEV#PBF IC DC/DC UMODULE 6A 118-LGA
LTM4603IV#PBF IC DC/DC UMODULE 6A 118-LGA
LTM4604AIV#PBF IC UMODULE DC/DC LV 4A 66-LGA
LTM4604IV#PBF IC DC/DC UMODULE 4A 66-LGA
LTM4605EV#PBF IC DC/DC UMODULE 5A 141-LGA
LTM4606MPV#PBF IC DC/DC UMODULE 6A 133-LGA
相关代理商/技术参数
LTM4601AHVEV#PBF 制造商:Linear Technology 功能描述:DC/DC Converter IC 制造商:Linear Technology 功能描述:IC, STEP-DOWN DC/DC MODULE, LGA-118
LTM4601AHVEVPBF 制造商:Linear Technology 功能描述:DC/DC Regulator 12A 20Vin PLL Tracking
LTM4601AHVEV-PBF 制造商:LINER 制造商全称:Linear Technology 功能描述:12A, 28VIN DC/DC μModule with PLL, Output Tracking and Margining
LTM4601AHVEY#PBF 功能描述:IC DC/DC UMODULE 12A 133-BGA RoHS:是 类别:电源 - 板载 >> DC DC Converters 系列:µModule® 设计资源:VI-200, VI-J00 Design Guide, Appl Manual 标准包装:1 系列:* 类型:隔离 输出数:1 电压 - 输入(最小):66V 电压 - 输入(最大):160V Voltage - Output 1:12V Voltage - Output 2:- Voltage - Output 3:- 电流 - 输出(最大):* 电源(瓦) - 制造商系列:50W 电压 - 隔离:* 特点:* 安装类型:通孔 封装/外壳:9-FinMod 尺寸/尺寸:4.60" L x 1.86" W x 0.79" H(116.8mm x 47.2mm x 20.1mm) 包装:散装 工作温度:-25°C ~ 85°C 效率:* 电源(瓦特)- 最大:*
LTM4601AHVEY#PBF 制造商:Linear Technology 功能描述:BUCK REGULATOR DC/DC UMODULE 12A BGA-
LTM4601AHVIV#PBF 功能描述:IC DC/DC UMODULE 12A 133-LGA RoHS:是 类别:电源 - 板载 >> DC DC Converters 系列:µModule® 设计资源:VI-200, VI-J00 Design Guide, Appl Manual 标准包装:1 系列:* 类型:隔离 输出数:1 电压 - 输入(最小):21V 电压 - 输入(最大):32V Voltage - Output 1:5V Voltage - Output 2:- Voltage - Output 3:- 电流 - 输出(最大):* 电源(瓦) - 制造商系列:100W 电压 - 隔离:* 特点:* 安装类型:通孔 封装/外壳:9-SlimMod 尺寸/尺寸:4.60" L x 1.80" W x 0.52" H(116.8mm x 45.7mm x 13.2mm) 包装:散装 工作温度:-25°C ~ 85°C 效率:* 电源(瓦特)- 最大:*
LTM4601AHVIV#PBF 制造商:Linear Technology 功能描述:DC/DC Converter IC
LTM4601AHVIV-PBF 制造商:LINER 制造商全称:Linear Technology 功能描述:12A, 28VIN DC/DC μModule with PLL, Output Tracking and Margining